2n Omega Lite - Configuration Tool manual v1.7 User Manual download pdf (Page 79)

2.8. Switches

Set the binary switch actions in this MENU section. You can create a table of

actions for each binary switch and specify for each switch which actions should be

executed upon its status change. You can set general switch actions for the whole

PBX or a group (1, 2) too.

2.8.1. Switch Settings

The table above shows all the switches installed in the PBX.

 Type  define the switch as a Binary input, or Relay contact.

 State  select OFF/ON for the Relay mode. The required Relay change will

occur when the configuration is stored in the PBX. With Binary, this field is

non-editable.

 Group  select whether or not the Binary input actions should affect a

selected group (DAY/NIGHT switching option). If no group is selected, the

subsequent actions are governed by the ON/OFF states independently on

the DAY/NIGHT mode.

 ON-state  the assigned action table is executed if the binary input transits

from the so-called logical 1, or the contact ON-state (e.g. motion sensor at

rest), into the so-called logical 0, or the contact OFF-state (e.g. motion

sensor activation).

 OFF-state  the assigned action table is executed if the binary input

changes from the so-called logical 0, or the contact OFF-state (e.g. motion

sensor active) into the so-called logical 1, or the contact ON-state (e.g.

motion sensor idle).

 Day/Night  applies to selected groups 1 or 2.

To assign a table, select one of the created ones, or create a new one. Use the

New command to open the action table defining dialogue.

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 111 112

No comments

2n Omega Lite - Configuration Tool manual v1.7 User Manual Page 79